Common dryer problems we fix
When a dryer stops working properly, it is almost always heat, tumble, or airflow. Here is what fails, and which part it points to. One note up front: a dryer that runs hot and takes forever is often a blocked vent, and a clogged vent is a real fire risk, so it is worth taking seriously.
Dryer runs but will not heat
No heat is our most common dryer call. On an electric dryer it is usually the heating element or a blown thermal fuse. On a gas dryer it is normally the igniter, which weakens with age until it can no longer light the burner, or the gas valve coils. A tripped thermal fuse often points back to restricted airflow, so we check the vent while we are there.
Dryer takes far too long to dry
Clothes still damp after a full cycle almost always means airflow is choked: a lint-clogged vent line, a crushed vent hose behind the machine, or a failing blower wheel. A worn moisture sensor can also end cycles early or run them long. Clearing the vent often fixes both the drying time and the safety risk in one go.
Dryer will not tumble
A drum that will not turn while the motor hums is usually a snapped belt, a seized idler pulley, or worn drum rollers. A dryer that is dead silent may be the drive motor or the start switch. We carry belts and rollers on the van for a same-visit fix on most models.
Dryer shuts off early or overheats
Shutting off after a few minutes points to a failing thermal fuse, a bad thermistor or moisture sensor, or an overheat caused, again, by a blocked vent. Overheating is worth fixing quickly, both for the clothes and for safety.
Dryer is loud
Rumbling, thumping or squealing usually comes from worn rollers, drum glides, or the idler pulley. Left too long, these strain the belt and motor, so it is cheaper to fix the noise early.
Dryer types and brands we service
Electric and gas dryers, plus vented, condenser and heat-pump models, from Samsung, LG, Whirlpool, Bosch, GE, Frigidaire, Maytag, Miele, Blomberg, Electrolux and more, including stacked and compact units.
Repair or replace your dryer?
Elements, igniters, thermal fuses, belts and rollers are low-cost parts and a fast fix, so those repairs are almost always worth it. We quote the full cost upfront, and the $79 service call is waived when you proceed with the repair.